Default settings for eS model – Pulsar Support

⚠️ Please note that the content of this article does not include our eS FS-1 model.

Thank you for choosing our eS model! We want to make sure you have the best experience with our product, so we've put together some information about the default settings for your eS model.

The default settings for the eS mouse are as follows:

DPI: 800
Polling Rate: 1000Hz
Debounce Time: 3ms
LOD: 1mm
Motion Sync: ON

Debounce Time Setting:

The debounce time setting on your eS model can be adjusted to 0mS, 3mS, 5mS, 7mS, 10mS, or 12mS.

DPI Setting:

The DPI setting on your eS model can be adjusted to 400DPI, 800DPI, 1600DPI, 3200DPI, 6400DPI, or 12800DPI.

For custom DPI settings. please check this article: How can I use a custom DPI on an eS Mice?

Polling Rate Setting:

In wired mode, the polling rate setting can be adjusted to 500Hz, 1000Hz, 2000Hz, 4000Hz, or 8000Hz.

In wireless mode, the polling rate setting can also be adjusted to 500Hz, 1000Hz, 2000Hz, or 4000Hz.

LOD (Lift off Distance) Setting:

The lift off distance setting on your eS model can be adjusted to 1mm or 2mm.

We hope this information helps you get the most out of your eS model.

If you have any further questions or need assistance with your mouse, please don't hesitate to contact our customer support team.